Compressive properties/compressive stress value/stress-strain characteristics in compression to ISO 3386
The compression stress value is the pressure resistance that a defined specimen under specified environmental conditions applies to a defined whole-surface compression.
Description Standards Running a test Video Testing systems Plastics brochure
Compression stress value
In this scenario, the deformation behavior of the specimen is relatively complex. Lateral movement of the cell structure with corresponding shearing occurs near the side cut surface, while the pure compression deformation is predominate in the center. For this reason it is not possible to effectively compare measured values that are determined from specimens of various dimensions using this test method.
Applicable standards for this test
The standard specimens have a quadratic cross-section with a lateral edge length of 5 or 100 mm. ASTM D3574 specifies an additional specimen with a round cross-section and a diameter of 57 mm.
- ASTM D3574 test C
- BMW QV 52009-1
- Daimler DBL 5452
- General Motors GMW 15471
- General Motors GME-GMI 60283-8
- ISO 3386-1, ISO 3386-2
- PSA D 41003
- PSA D 411541
- Renault N° 1002
- Renault N° 1541
- Toyota TSM 7100 G Section 4.2
- Volkswagen PV 3410
Generally the test consists of three preload cycles, followed by a measuring cycle in which the characteristic values are determined. The initial height of the specimen is determined directly by the testing machine at the beginning of the first preload cycle. According to ASTM D3574, the height and travel-zero point is redetermined before the measuring cycle. Variations of this method are described in the various factory regulations.
The methods used by Renault and PSA are exceptions. The test consists of a total of five test cycles, of which the first and the last are evaluated. To increase the accuracy of the travel measurement, this standard specifies the correction for machine deformation. These correction options are available with all ZwickRoell testing machines as a standard function.
The density measurement process can be integrated in the test sequence. Density is measured using a scale that is connected to the PC.
Take advantage of the leading testing software in materials testing
ZwickRoell’s testXpert testing software offers:
- Simple operation: start testing right away and be a testXpert while maintaining maximum safety.
- Reliable and efficient testing: benefit from reliable test results and maximum testing efficiency.
- Flexible integration: testXpert is the optimal solution for all of your applications and processes—simply put, a more effective workflow.
- Future-proof design: testing software for the entire life cycle, ready for your future test tasks!